M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario descargar pdf (Pagina 18)

APPENDIX 4

Scribble Strips. And when you have adjusted the controls, another press on

the F5 button takes you back to the view that you were in previously.

Keyboard Modifier Switches

To the left of the fader section there are four modi er keys corresponding to

the modi er keys on your computer keyboard. These are labeled the same way

as the modi er keys on Apple computers, so you have Shift, Option, Control,

and Command. You can use these in the same way as those on the computer

keyboard in combination with other key presses on the computer keyboard or

with mouse clicks.

The Shift/Add Switch allows you to extend a track selection or add to a group

of selected items. The Option/All Switch applies an action or command to all

the tracks in a Pro Tools session. So, for example, this is very useful if you want

to insert an EQ plug-in onto every track: just hold the Option key while you are

inserting the plug-in onto the  rst track and it will insert it onto every track

of the same type. The Control/Clutch Switch temporarily stops a control from

acting as part of a group of controls. If you need  ner adjustment of any Pro

Tools controls or automation breakpoints, simply hold down the Command

Switch while you adjust these and small increments will become possible.

Digi 002 Modes

The Digi 002 goes into Standby mode when you power it up and it waits in this

mode until you either launch Pro Tools LE or switch to Standalone mode. When

the Digi 002 is connected to a computer with Pro Tools LE software running, it

goes into Pro Tools mode.

The Digi 002 can also be used as a standalone eight-channel digital audio

mixer – with or without being connected to the computer. You can switch to

Standalone mode either from Standby mode or from Pro Tools mode when

your computer is no longer needed for Digi 002 to operate.

Standalone Mode

To put the Digi 002 into Standalone mode, just press the Standalone switch

on the right-hand side of the Digi 002 top panel and con rm that you want to

enter Standalone mode by pressing the Channel Select switch that is  ashing

under the word ‘Yes’. To exit Standalone mode, simply press the Standalone

switch a second time. Digi 002 goes into Standby mode, or re-enters Pro Tools

mode automatically if Pro Tools software is still running.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

Sin comentarios

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario Pagina 18