M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario descargar pdf (Pagina 8)

APPENDIX 4

To the left of these, there is a footswitch jack that you can use to punch-in

and-out of record and to the right there are three 5-pin DIN MIDI sockets:

one MIDI In, and two MIDI Outs allowing for 16 channels of MIDI input and

32channels of MIDI output.

Finally, the power connector will accept AC supplies between 100 and 240 volts

running at either 50 or 60 Hz – so you can connect the Digi 002 to the main

electricity supplies in most countries around the world without problems.

The Control Surface

The Digi 002 control surface is divided into two main sections with the input

gain and output level controls at the top and the other controls below.

The main section is further sub-divided to group the control knobs, more

switches, and the ‘scribble strip’ displays in the middle section with the moving

faders below these in the lowest section and the transport controls to the right

of these.

Figure A4.4

Digi 002 control

surface (no longer

manufactured).

Top Section

Let’s look at the top section first. At the top left there are four rotary gain

controls for the four microphone preampli ers. Above these there are four

pairs of buttons. The  rst of each pair switches the input between microphone

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 52 53

Sin comentarios

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario Pagina 8