M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario descargar pdf (Pagina 16)

If you press the Command switch at the same time as the Display Mode switch, the

channels will display numerical parameter values rather than control names. For example,

in Pan View, when you press Command + Display, fader volume levels in decibel are

shown as the default display.

You can also show the Pro Tools main Counter in the Display Scribble Strips by pressing

the Display Mode switch, which is located right between the Display Scribble Strips and

the Channel Scribble Strips. So you can see the Bar:Beat location or the SMPTE location

or whatever the main Counter is set to.

More Buttons and Status Indicators

There are various LEDs and buttons located below the Display Scribble Strips. Four

LEDs indicate the sampling rate: 44.1, 48, 88.2, or 96 kHz.

Three buttons underneath these let you select Enter, Undo, and the Standalone mode.

Three more LEDs to the right of these indicate MIDI input and output activity.

To the left, you will find the Record Enable button. When this button is pressed, you can

arm any track for record by pressing its Channel Select button on the Digi 002.

Rotary Encoders

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 70 71

Sin comentarios

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario Pagina 16