M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario descargar pdf (Pagina 27)

onto every track: just hold down the Option key while you are inserting the plug-in onto

the first track, and it will insert it onto every track of the same type. The Control/Clutch

Switch temporarily stops a control from acting as part of a group of controls. If you need

finer adjustment of any Pro Tools controls or automation breakpoints, simply hold down

the Command Switch while you adjust these and small increments will become possible.

002 Modes

The Digi 002 goes into Standby mode when you power it up, and it waits in this mode

until you either launch Pro Tools LE or switch to Standalone mode. When the Digi 002 is

connected to a computer with Pro Tools LE software running, it goes into Pro Tools

mode.

The Digi 002 can also be used as a stand-alone, eight-channel digital audio mixer—with

or without being connected to the computer. You can switch to Standalone mode either

from Standby mode or from Pro Tools mode and your computer is no longer needed for

Digi 002 to operate.

Standalone Mode

To put the Digi 002 into Standalone mode, just press the Standalone switch on the right-

hand side of the Digi 002 top panel and confirm that you want to enter Standalone mode

by pressing the Channel Select switch that is flashing under the word “Yes.” To exit

Standalone mode, simply press the Standalone switch a second time. Digi 002 either goes

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 70 71

Sin comentarios

M-Audio 37-Key Audio/MIDI Interface and Controller Ozonic Manual de usuario Pagina 27